Weld on Frame Brace

$50.00
(1 review) Write a Review
Current Stock:

These weld on braces are for added support to the factory mounting which is very weak and bends easily.

-05 plus tacoma

-Made from 3/16" plate

-Comes with the pair of plates and 1/2" hardware

* Remove factory or aftermarket bumper. Cut the bumper studs off and press the old ones out. Take a 1/2" drill bit or unibit and open the holes to 1/2".

Place the new hardware in the holes, center the brace up and tighting down the hardware so the plate wont move. Weld the heads of the bolts around the factory mount on the back side then weld the new plates to the frame. Unbolt and reinstall your bumper. Ta-da no more bent mounting.

Reviews

  • 4
    Bumper reinforcements

    Posted by Jedadiah on Aug 19th 2020

    Plates seem very strong unlike the stock mounting points, however there was no hardware with it like the pictures